ABB ACS180 - Set the Drive Parameters; Open Diagnostics

Start-up, ID run and use 25
Set the drive parameters
Open Diagnostics
1. Select the Main menu from the Home view (by pressing
OK button).
2. Scroll to Parameters, and press the OK button to open
the submenu.
3. Select the complete parameters list with the arrow button
and press the OK button, or
4. Select the modified parameters list with the arrow button
and press the OK button.
5. Select the parameter and press the OK button to adjust
the value.
The parameters are shown in respective groups. The
first two digits of the parameter number represent the
parameter group. For example, parameters starting with
30 are in the Limits group.
See chapter Parameters for more information.
1. Select the Main menu from the Home view (by pressing
OK button).
2. Scroll to Diagnostics and press the OK button to open
the submenu.
3. Select the warning or fault with the arrow button and
press the OK button.
See chapter Fault tracing for more information.
ACS180 FW.book Page 25 Tuesday, March 9, 2021 2:25 PM