Control macros 27
Control macros
Contents
• ABB standard macro
• Hand/Auto macro
• Hand/PID macro
• Modbus RTU macro
• Alternate macro
• Motor potentiometer macro
• PID macro
Control macros are sets of default parameter values that apply to a specific control
configuration. They make it faster and easier to set up a drive for use.
By default, macro is set as ABB standard macro.
ABB standard macro
ABB standard macro is suitable for an I/O-controlled drive. Digital inputs control
start/stop (2-wire), direction and constant speed selection (3 speeds).
You can activate the macro from the Control macros view, or by setting parameter
96.04 Macro select to value ABB standard.
This is the default macro for drive ACS180-04.
ACS180 FW.book Page 27 Tuesday, March 9, 2021 2:25 PM
To Next Page
Loading...
