94 Program features
Overspeed protection (parameter 31.30)
The user can set overspeed (and overfrequency) limits by specifying a margin that is
added to the currently-used maximum and minimum speed (or frequency) limits.
Local control loss detection (parameter 49.05)
The parameter selects how the drive reacts to a control panel or PC tool
communication break.
AI supervision (parameters 12.03…12.04)
The parameters select how the drive reacts when an analog input signal moves out of
the minimum and/or maximum limits specified for the input.
Ramp stop supervision (parameters 31.32, 31.33, 31.37 and 31.38)
The control program has a supervision function for both the normal and emergency
stop ramps. The user can either define a maximum time for stopping, or a maximum
deviation from the expected deceleration rate. If the drive fails to stop in the expected
manner, a fault is generated and the drive coasts to a stop.
Custom motor current fault limit (parameter 31.30)
The control program sets a motor current limit based on drive hardware. In most
cases, the default value is appropriate. However, a lower limit can be manually set by
the user, for example, to protect a permanent magnet motor from demagnetization.
ACS180 FW.book Page 94 Tuesday, March 9, 2021 2:25 PM
To Next Page
Loading...
