Parameters 117
07.07 Loading package
version
Version number of the firmware loading package. -
07.11 Cpu usage Microprocessor load in percent. -
0…100% Microprocessor load. 1 = 1-
07.30 Adaptive program
status
Shows the status of the adaptive program.
See section Adaptive programming on page 56.
-
0000h…FFFFh Adaptive program status 1 = 1
07.31 AP sequence state Shows the number of the active state of the sequence
program part of the adaptive program (AP). If adaptive
programming is not running, or it does not contain a
sequence program, the parameter is zero.
0...20 1 = 1
07.35 Drive configuration Plug ‘n’ play configuration. Parameter shows the drive
initial HW configuration.
0000h
0000h…FFFFh 1 = 1
No. Name/Value Description Default
FbEq 16
Bit Name Description
0 Initialized Adaptive program initialized.
1 Editing Adaptive program in editing state.
2 Edit done Editing of the adaptive program finished.
3 Running Adaptive program running.
4-13 Reserved
14 State changing State changing on-going in the adaptive programming engine.
15 Faulted Adaptive program faulted.
Bit Name Description
0 Not initialized Drive is not configured. In next power up HW configuration is done as
Plug ‘n’ Play.
1 Base unit Drive is configured to Base unit.
2 BMIO-01 Drive is configured to use BMIO-01 module.
3 FENA-21 Drive is configured to use FENA-21-M module.
4 FECA-01 Drive is configured to use FECA-01-M module.
5 FPBA-01 Drive is configured to use FPBA-01-M module.
6 FCAN-01 Drive is configured to use FCAN-01-M module.
7 BCAN-11 Drive is configured to use BCAN-11 module.
9...15 Reserved.
To Next Page
Loading...
