12 Introduction to the manual
Target audience
The reader is expected to know the fundamentals of electricity, wiring, electrical
components and electrical schematic symbols.
The manual is written for readers worldwide. Both SI and imperial units are shown.
Purpose of the manual
This manual provided information for designing, commissioning, or operating the
drive system.
Contents of the manual
• Introduction to the manual (this chapter) describes the applicability, purpose and
content of the manual, and terms and conditions.
• Control panel (page 17) introduces the internal control panel.
• Start-up, ID run and use (page 23) contains instructions on how to start up the
drive and perform the ID run, and descriptions of the main use cases.
• Control macros (page 29) contains macro connection diagrams and descriptions.
• Program features (page 49) describes the program features and parameters.
• Parameters (page 101) lists the parameters.
• Additional parameter data (page 313) lists the 32-bit parameters used to program
the drive.
• Fault tracing (page 345) lists faults and warnings with their explanations and
solutions.
• Fieldbus control through the embedded fieldbus interface (EFB) (page 367)
describes the communication to and from a fieldbus network using the embedded
fieldbus interface of the drive.
• Fieldbus control through a fieldbus adapter (page 431) describes the
communication to and from a fieldbus network using an optional fieldbus module.
• Control chain diagrams (page 445) presents the reference chains of the drive.
To Next Page
Loading...
