100 Program features
The following example shows the behavior of the motor potentiometer value.
Parameters
Parameters: 22.71…22.80.
User lock
For better cyber security, you can set a master password to prevent eg. the changing
of parameter values and/or the loading of firmware and other files.
To activate the user lock for the first time, enter the default pass code, 10000000, into
96.02 Pass code. This will make parameters 96.100…96.102 visible. Then enter a
new pass code into 96.100 Change user pass code, and confirm the code in 96.101
Confirm user pass code. In 96.102 User lock functionality, define the actions that you
want to prevent.
To close the user lock, enter an invalid pass code into 96.02 Pass code, activate
96.08 Control board boot, or cycle the power. With the lock closed, parameters
96.100…96.102 are hidden.
To reopen the lock, enter your pass code into 96.02 Pass code. This will again make
parameters 96.100…96.102 visible.
Settings
Parameters: 96.02 and 96.100…96.102.
0
1
0
1
0
22.80
22.74
22.73
22.77
22.76
22.75
To Next Page
Loading...
