120 Parameters
08.03 Fault time hi Time (real time or power-on time) at which the active fault
occurred in format dd.mm.yy (day, month and year).
1 = 1 d
08.04 Fault time lo Time (real time or power-on time) at which the active fault
occurred in format hh.mm.ss (hours, minutes and seconds).
1 = 1
08.05 Alarm logger1 Alarm logger 1. For possible causes and remedies, see
chapter Fault tracing on page 289. Can be reset by entering a
0.
-
08.06 Alarm logger2 Alarm logger 2. For possible causes and remedies, see
chapter Fault tracing on page 289. Can be reset by entering a
0.
-
No. Name/Value Description FbEq
Bit Name
0 Brake start torq
1 Brake not closed
2 Brake not open
3 Safe torq off
4 Sto mode
5 Motor temp1
6Em off
7 Run enable
8Id run
9Em stop
10 Position scaling
11 Br overtemp
12 BC igbt overtemp
13 Device overtemp
14 Int board ovtemp
15 BC mod overtemp
Bit Name
0 Inu overtemp
1FBA comm
2 Panel loss
3 AI supervision
4FBA par conf
5 No motor data
6 Encoder1
7 Encoder2
8 Latch pos1
9 Latch pos2
10 Enc emul
11 FEN temp meas
12 Emul max freq
13 Emul pos ref
14 Resolver atune
15 Enc1 cable
To Next Page
Loading...
