ABB ACS850 - Page 127

Parameters 127
Timed func Bit 4 of parameter 06.14 Timed func stat. The bit is on when
any one of the four timers configured in parameter group 36
Timed functions is on.
1074005518
Const Bit pointer setting (see Terms and abbreviations on page
102).
-
Pointer
10.06 Ext2 start in2 Selects source 2 of start and stop commands for external
control location EXT2. See parameter 10.04 Ext2 start func,
selection 3-wire.
Note: This parameter cannot be changed while the drive is
running.
DI2 Digital input DI2 (as indicated by 02.01 DI status, bit 1). 1073807873
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
DIO5 Digital input/output DIO5 (as indicated by 02.03 DIO status,
bit 4).
1074004483
Const Bit pointer setting (see Terms and abbreviations on page
102).
-
Pointer
10.07 Jog1 start If enabled by parameter 10.09 Jog enable, selects the source
for the activation of jogging function 1. (Jogging function 1
can also be activated through fieldbus regardless of
parameter 10.09.)
1 = Active.
See also other jogging function parameters: 10.08 Jog2 start,
10.09 Jog enable, 21.07 Speed ref jog1, 21.08 Speed ref
jog2, 22.10 Acc time jogging, 22.11 Dec time jogging and
19.07 Zero speed delay.
Note: This parameter cannot be changed while the drive is
running.
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by
02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
DI6 Digital input DI6 (as indicated by 02.01 DI status, bit 5). 1074070017
DIO4 Digital input/output DIO4 (as indicated by 02.03 DIO status,
bit 3).
1073938947
DIO5 Digital input/output DIO5 (as indicated by 02.03 DIO status,
bit 4).
1074004483
Const Bit pointer setting (see Terms and abbreviations on page
102).
-
Pointer
10.08 Jog2 start If enabled by parameter 10.09 Jog enable, selects the source
for the activation of jogging function 2. (Jogging function 2
can also be activated through fieldbus regardless of
parameter 10.09.)
1 = Active.
See also parameter 10.07 Jog1 start.
Note: This parameter cannot be changed while the drive is
running.
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
DI6 Digital input DI6 (as indicated by 02.01 DI status, bit 5). 1074070017
No. Name/Value Description FbEq