ABB ACS880-07 Series - Layout of the input and motor cable connection terminals (frames R10 and R11); Layout of the input and motor cable connection terminals (frames R10 and R11 with option +C129)

￭ Layout of the input and motor cable connection terminals (frames R10
and R11)
Strain relief1


W2V2U2
L1 L2 L3
1
2
Input power cable terminalsL1, L2, L3
Motor cable terminalsU2, V2, W2
PE terminal2
￭ Layout of the input and motor cable connection terminals (frames R10
and R11 with option +C129)
Strain relief1


W2
V2
U2
L1 L2
L3
1
2
Input power cable terminalsL1, L2, L3
Motor cable terminalsU2, V2, W2
PE terminal2
￭ Entry of external resistor and DC cables
Run the external brake resistor cables and DC cables into the drive cabinet through the
power cable entries at the base of the drive module cubicle. In frames R6 to R8 the
connection terminals are in the drive module. In frame R9, the connection terminals are
located below the drive module.
118 Electrical installation