ABB ACS880-07 Series - Moving the Cabinet with Rollers; Moving the Cabinet to Its Final Placement with a Slate Bar; Moving the Cabinet on Its Back

￭ Moving the cabinet with rollers
WARNING!
Do not move marine versions (option +C121) on rollers.
Lay the cabinet on the rollers and move it carefully
until close to its final location.
Remove the rollers by lifting the unit with a crane,
forklift, pallet truck or jack.
￭ Moving the cabinet to its final placement with a slate bar
Move the cabinet into its final position with an iron bar.
Place a wooden piece at the bottom edge of the cabinet
in order not to damage the cabinet frame with the iron
bar.
￭ Moving the cabinet on its back
WARNING! Do not transport the drive with a sine filter (option +E206) on its back.
It will damage the filter.
If you need to lay the cabinet on its back, support from below alongside the cubicle seams.
1
2
Cabinet back panel1
Support2
74 Mechanical installation
4