Do not install the drive on an elevated platform or a recess. The module extraction/installation
ramp included with the drive is only suitable for a height difference of 50 mm (2 in) maximum
(ie. the standard plinth height of the drive).
Necessary tools
The tools required for moving the unit to its final position, fastening it to the floor and wall
and tightening the connections are listed below:
• crane, fork-lift or pallet truck (check load capacity!), slate/spud bar, jack and rollers
• Pozidriv and Torx screwdrivers
• torque wrench
• set of wrenches or sockets.
Moving the drive in its package
Move the drive in its original packaging to the installation site as shown below to avoid
damaging the cabinet surfaces and door devices. When you are using a pallet truck, check
its load capacity before you move the drive.
￭ Horizontal package
Move the drive package in horizontal position, preferably in the original package to installation
site as shown below to avoid damaging the cabinet surfaces and door devices. When you
use a pallet truck, check its load capacity before you move the drive.
66 Mechanical installation
To Next Page
Loading...
