Generally all metals, such as steel, aluminum, copper and its alloys, and precious metals
can be recycled as material. Plastics, rubber, cardboard and other packaging material can
be used in energy recovery. Printed circuit boards and large electrolytic capacitors need
selective treatment according to IEC 62635 guidelines. To aid recycling, plastic parts are
marked with an appropriate identification code.
Contact your local ABB distributor for further information on environmental aspects and
recycling instructions for professional recyclers. End of life treatment must follow international
and local regulations. See ACS880 cabinet-installed drives recycling instructions and
environmental information (3AXD50000153909 [English]).
Applicable standards
The drive complies with the standards below. The compliance with the European Low
Voltage Directive is verified according to standard EN 61800-5-1.
Adjustable speed electrical power drive systems. Part 5-1: Safety requirements–
electrical, thermal and energy
IEC/EN 61800-5-1:2007
Semiconductor converters – General requirements and line commutated converters
– Part 1-1: Specification of basic requirements
IEC 60146-1-1:2009
EN 60146-1-1:2010
Degrees of protection provided by enclosures (IP code).
IEC 60529:1989
EN 60529:1991
Safety of machinery. Electrical equipment of machines. Part 1: General require-
ments.
IEC 60204-1:2005 +
A1:2008
EN 60204-1:2006 +
AC:2010
Adjustable speed electrical power drive systems. Part 3: EMC requirements and
specific test methods
IEC/EN 61800-3:2004
Enclosures for Electrical Equipment, Environmental considerations
UL 50E 1st Edition:2007
Industrial Control Panels
UL 508A 2nd Edition:2013
Enclosures for Electrical Equipment, Non-Environmental Considerations
UL 50 12th Edition:2007
Industrial control equipment
CSA C22.2 No. 14-
18:2013
Enclosures for electrical equipment, environmental considerations
CSA C22.2 No. 94.2-07
Markings
CE mark
Product complies with the applicable European Union legislation. For fulfilling the EMC requirements,
see the additional information concerning the drive EMC compliance (IEC/EN 61800-3).
UL Listed mark for USA and Canada
Product has been tested and evaluated against the relevant North American standards by the Un-
derwriters Laboratories. Valid with rated voltages up to 600 V.
228 Technical data
To Next Page
Loading...
