Installing the IP54 roof
If the roof of an IP54 cabinet is delivered in a separate package, install the roof as follows.
￭ Frames R6 to R8
1. Undo the mounting screws of the front top profile of the cabinet and remove it.
2. Undo the back mounting screws of the roof from the cabinet top. See step 1 under section
Frames R10 and R11 (page 76)
3. Remove the IP54 filter grating and connect the fan power supply wires.
4. Install the front top profile of the cabinet in reverse order to step 1.
5. Fasten the back mounting screws of the roof.
6. Install the IP54 filter grating.
Mechanical installation 75
To Next Page
Loading...
