Quick installation, commissioning and operation flowchart
SeeTask
Guidelines for planning the electrical installa-
tion (page 85)
Plan the electrical installation and acquire the accessor-
ies needed (cables, fuses, etc.).
Check the ratings, required cooling air flow, input power
connection, compatibility of the motor, motor connec-
tion, and other technical data.
Technical data (page 197)
Ambient conditions (page 225)
Check the installation site.
Mechanical installation (page 65)
Unpack and check the drive (only intact units may be
started up).
Make sure that all necessary optional modules and
equipment are present and correct.
Install the drive mechanically.
Routing the cables (page 97)
Route the cables.
Measuring the insulation (page 109)
Check the insulation of the supply cable, the motor and
the motor cable.
Grounding system compatibility check (page 111)
If the drive is about to be connected to an IT (ungroun-
ded) system, check that the drive is not equipped with
EMC filter (option +E202).
Electrical installation (page 109)
Connect the power cables.
Connect the control cables.
Installation checklist (page 153)
Check the installation.
If the drive has been non-operational for more than one
year, reform the DC link capacitors. See Converter
module capacitor reforming instructions
(3BFE64059629 [English].
Start-up (page 155)
Start the drive up.
Quick start-up guide, firmware manual
Operate the drive: start, stop, speed control etc.
Terms and abbreviations
DescriptionTerm
Industrial assistant non-Bluetooth control panelACS-AP-I
Industrial assistant control panel with Bluetooth interfaceACS-AP-W
Common mode filteringCMF
Distributed drives communication system protocolDDCS
Frequency converter for controlling AC motorsDrive
Direct torque control, a motor control methodDTC
Electromagnetic compatibilityEMC
26 Introduction to the manual
To Next Page
Loading...
