69Unpacking the transport package ...............................................................
70Lifting the cabinet ..................................................................................
70Lifting from the cabinet from the horizontal package ......................................
71Lifting the cabinet with crane .................................................................
71Lifting lugs .......................................................................................
71Certificate of conformity ....................................................................
72Declaration of Conformity ..................................................................
73Moving the cabinet after unpacking .............................................................
74Moving the cabinet with rollers ...............................................................
74Moving the cabinet to its final placement with a slate bar ................................
74Moving the cabinet on its back ...............................................................
75Installing the IP54 roof ............................................................................
75Frames R6 to R8 ...............................................................................
76Frame R9 ........................................................................................
76Frames R10 and R11 ..........................................................................
77Attaching the cabinet to the floor and wall or roof .............................................
77General rules ....................................................................................
78Attaching the cabinet (non-marine units) ...................................................
78Alternative 1 – Clamping ...................................................................
79Alternative 2 – Using the holes inside the cabinet .....................................
80Alternative 3 – Cabinets with plinth options +C164 and +C179 ......................
81Attaching the cabinet (marine units) .........................................................
82Miscellaneous ......................................................................................
82Cable duct in the floor below the cabinet ...................................................
82Arc welding ......................................................................................
82Air inlet through the bottom of cabinet (option +C128) ...................................
83Air outlet duct on the cabinet roof (option +C130) .........................................
84Calculating the required static pressure difference ....................................
5 Guidelines for planning the electrical installation
85Contents of this chapter ...........................................................................
85Limitation of liability ................................................................................
85Selecting the supply disconnecting device .....................................................
85Selecting the main contactor .....................................................................
86Examining the compatibility of the motor and drive ...........................................
86Protecting the motor insulation and bearings ..............................................
86Requirements table ............................................................................
89Availability of du/dt filter and common mode filter by drive type .....................
89Additional requirements for explosion-safe (EX) motors ..............................
89
Additional requirements for ABB motors of types other than M2_, M3_, M4_, HX_
and AM_ ......................................................................................
89Additional requirements for ABB high-output and IP23 motors ......................
89Additional requirements for non-ABB high-output and IP23 motors .................
90Additional data for calculating the rise time and the peak line-to-line voltage .....
91Additional note for sine filters .............................................................
91Selecting the power cables .......................................................................
91General guidelines .............................................................................
92Typical power cable sizes .....................................................................
92Power cable types ..............................................................................
92Preferred power cable types ..............................................................
93Alternate power cable types ...............................................................
94Not allowed power cable types ...........................................................
Table of contents 7
To Next Page
Loading...
