Chapter 3: Configuration 3.6 Setting the Configuration
493-0736-11 (6-2) 181
Note. All signal types can be used together with the Stiction Compensation
function. This means, for example, that the function can be added to an external
input signal and then be distributed as an output signal with the stiction
compensation pulses superimposed.
Analog Output Communication Buffers
Remote analog communication is provided by Analog Output Communications
Buffers (AOC) via a two wire RS485 serial channel using the COMLI protocol.
Each Analog Output Communications Buffer can accept one analog input and
produces one analog output. Each buffer block also holds two parameters, Mode
and Identity. Each block may be given a twenty letter identification name by
configuring the parameter Identity.
Note. See Appendix E for a full list of communication I/O bits and registers.
Table 135 Analog Output Communications Buffer Inputs.
Table 136 Analog Output Communications Buffer Parameters.
Inputs
Name Connection
Signal Off, Analog
Parameters
Name Setting Unit
Mode Off, On None
Identity User defined text None
Available in
ECA06 ECA60 ECA600 EMA60
4 8 12 4
Communication
Analog
Output
Comms
Buffer
Signal
To Next Page
Loading...
