3.6 Setting the Configuration Chapter 3: Configuration
182 493-0736-11 (6-2)
Digital Outputs
Each Digital Output Block (DO) has one digital input, Signal and provides one
digital signal to the external terminals of the controller. Each block also holds two
parameters – Mode and Identity.
The Mode parameter is used to select the block for operation and whether it
operates in the Positive Logic or Negative Logic modes.
The block can be given a twenty letter name by setting the parameter Identity.
Table 137 Digital Output Block Inputs.
Table 138 Digital Output Block Parameters.
Inputs
Name Connection
Signal Off, Digital
Parameters
Name Setting Unit
Mode Off, PositiveLogic, NegativeLogic None
Identity User defined None
Available in
ECA06 ECA60 ECA600 EMA60
2466
Signal
Digital
Output
Screw Terminals
To Next Page
Loading...
