Chapter 3: Configuration 3.6 Setting the Configuration
493-0736-11 (6-2) 67
• Each block may be given a twenty letter identification name by configuring the
parameter Identity.
Analog Input Communication Buffers
Remote analog communication is provided by Analog Input Communications
Buffers (AIC) via a two wire RS485 serial channel using a communication
protocol. Each Analog Communications Buffer can accept one register value and
produces one analog output, Val u e. Each buffer block also holds two parameters.
Table 6 Analog Input Communications Buffer Parameters.
Table 7 Analog Input Communications Buffer Outputs.
To select an analog input for use, configure the parameter Mode to on. To deselect
an analog input, set the parameter Mode to Off.
Each block may be given a twenty letter identification name by configuring the
parameter Identity.
Each buffer corresponds to one unique register. See Appendix E for a full list of
registers and their addresses.
Parameters
Name Setting Unit
Mode Off, On None
Identity User defined text None
Outputs
Name Type
Value Analog
Available in
ECA06 ECA60 ECA600 EMA60
4 8 12 4
Communication
Analog
Input
Comms
Buffer
Va lue
To Next Page
Loading...
