3.6 Setting the Configuration Chapter 3: Configuration
68 493-0736-11 (6-2)
Analog User Blocks
Analog User Blocks (AU) can be configured so that the operator can enter analog
values using the front panel keys. These user defined inputs are added to the
operator option list if they are enabled during Configuration. The blocks can be
set to Ratio or Bias Values while the controller is in operation.
Each block produces one analog output signal, Val ue . Each block also holds seven
parameters.
Table 8 Analog User Block Parameters.
Parameters
Name Setting Unit
Mode Off, On None
NumberOfDecimals 0 ≤ NumberOfDecimals ≤ 4None
LoLimit –99999 ≤ LoLimit ≤ 99999 None
HiLimit –99999 ≤ HiLimit ≤ 99999 None
Identity User defined text None
MinValue –100.0 ≤ MinValue ≤ MaxValue ≤
100.0
%
MaxValue –100.0 ≤ MinValue ≤ MaxValue ≤
100.0
%
Available in
ECA06 ECA60 ECA600 EMA60
-284
Front Keys
Analog
User
Block
Va lu e
To Next Page
Loading...
