Chapter 3: Configuration 3.6 Setting the Configuration
493-0736-11 (6-2) 73
Digital User Blocks
Digital User Blocks (DU) can be configured so that the operator can enter digital
levels using the front panel keys. These user defined inputs are added to the
operator option list if they are enabled during Configuration. When a block
represents a False value the text “False” is shown on the display. When the block
represents a True value the text “True” is shown on the display.
Each block can accept one digital input and produces one digital output signal,
Status. Each block also holds two parameters, Mode and Identity.
Table 14 Digital User Block Parameters.
Table 15 Digital User Block Outputs.
To enable a Digital User Block, set the parameter Mode to on. To disable the block
set Mode to Off. Each block may be given a twenty letter identification name by
configuring the parameter Identity.
Parameters
Name Setting Unit
Mode Off, On None
Identity User defined text None
Outputs
Name Type
Status Digital
Available in
ECA06 ECA60 ECA600 EMA60
-284
Front Keys
Digital
User
Block
Status
To Next Page
Loading...
