ABB ECA06 - Page 72

3.6 Setting the Configuration Chapter 3: Configuration
72 493-0736-11 (6-2)
Each block may be given a twenty letter identification name by configuring the
parameter Identity
Digital Input Communications Buffers
Remote digital communication is provided by Digital Input Communications
Buffers (DIC). Via communication a master can feed digital values to the
controller. This is done by writing a bit value into the I/O bit area.
Each Digital Communications Buffer represents a I/O bit.
To configure a Digital Communications Buffer for use, set the parameter Mode to
on. To deselect a digital buffer, set the parameter Mode to Off.
Each block may be given a twenty letter identification name by configuring the
parameter Identity.
Each buffer corresponds to one unique I/O bit.
Note. See Appendix E for a full list of I/O bits and their addresses.
Table 12 Digital Input Communications Buffers Parameters.
Table 13 Digital Input Communications Buffers Outputs.
Parameters
Name Setting Unit
Mode Off, On None
Identity User defined text None
Outputs
Name Type
Status Digital
Available in
ECA06 ECA60 ECA600 EMA60
4 8 12 4
Communication
Digital
Input
Comms
Buffer
Status