ABB ECA06 - Page 71

Chapter 3: Configuration 3.6 Setting the Configuration
493-0736-11 (6-2) 71
When an analog user block is activated, it appears in the Operator Option List.
Here the operator can adjust the (output) signal by pressing the UP/DOWN keys.
It is possible to make the Displayed Range differ from the Signal Range by
changing the parameters LoLimit and HiLimit.
The default values of LoLimit (0.0) and HiLimit (100.0) define the default
(displayed) range
–100.0 ≤ Displayed Value ≤ 100.0
LoLimit determines the value displayed for MinValue, and HiLimit determines
the value displayed for MaxValue.
Digital Inputs
Digital Input Blocks (DI) can accept one digital input signal and produce one
digital output signal, Status. Each block also holds two parameters.
Table 10 Digital Input Block Parameters.
Table 11 Digital Input Block Outputs.
To select a digital input for use, set the parameter Mode to the required logic
mode. To deselect a digital input, set the parameter Mode to Off.
Parameters
Name Setting Unit
Mode Off, PositiveLogic, NegativeLogic None
Identity User defined text None
Outputs
Name Type
Status Digital
Available in
ECA06 ECA60 ECA600 EMA60
1342
Screw Terminals
Digital
Input
Block
Status