Chapter 3: Configuration 3.6 Setting the Configuration
493-0736-11 (6-2) 81
Summary
Table 29 Summary of Comp Parameters.
Note: All pressure parameters must be given the same engineering unit.
Term Type Unit Comment
Factor Constant None -
P
diff
Analog input None Differential pressure signal from
differential pressure sensor.
Signal not linearized.
P
abs
Analog input None Absolute pressure sensor signal.
Set to Off if no absolute pressure
compensation is required.
P
absMax
Constant see note Pressure sensor upper measuring
range limit (absolute pressure).
P
absMin
Constant see note Pressure sensor lower measuring
range limit (absolute pressure).
P
orifice
Constant see note Orifice plate design pressure.
T
orifice
Constant °C Orifice plate design temperature.
T Analog input None Temperature signal (linearised)
from transmitter. Set to Off if no
temperature compensation is
required.
T
max
Constant °C Temperature sensor upper
measuring range limit.
T
min
Constant °C Temperature sensor lower
measuring range limit.
To Next Page
Loading...
