ABB ECA06 - Page 80

3.6 Setting the Configuration Chapter 3: Configuration
80 493-0736-11 (6-2)
Table 27 Comp Parameters.
Table 28 Comp Outputs.
If only absolute pressure compensation is required set T = Off:
If only temperature compensation is required set P
abs
= Off:
Parameters
Name Setting Unit
Factor –10.0 ≤ K ≤ 10.0 none
P
absMax
0.0 ≤ P
absMax
≤ 10000.0 see note
P
absMin
0.0 ≤ P
absMin
≤ 10000.0 see note
P
orifice
0.0 ≤ P
orifice
≤ 10000.0 see note
T
orifice
–273.0 ≤ T
orifice
≤ 10000.0 °C
T
max
–273.0 ≤ T
max
≤ 10000.0 °C
T
min
–273.0 ≤ T
min
≤ 10000.0 °C
Outputs
Name Type
Value Analog signal
Value Factor P
diff
P
abs
P
absMax
P
absMin
–()P
absMin
+
×
P
orifice
-------------------------------------------------------------------------------------------------------------
×× =
Value Factor P
diff
T
orifice
273+
TT(
max
T
min)
)– T
min)
273++
×
-------------------------------------------------------------------------------------------
×× =