NoteAction
xx1200000859
Note
Valid for Type C and Other design (1) than
Type C
Measure the oil level by looking into the hole
of the oil plug inspection.
Required oil level:
• up to the lower edge of the oil plug
hole of the oil plug inspection.
5
Parts:
A Oil plug inspection
B Approximate oil level
xx1000000824
Note
Valid for Other design (2) than Type C:
Measure the oil level at the oil plug hole.
Required oil level:
• 35 ± 3 mm below the surface for the
motor flange.
The oil level shall only just start to be ob-
served when looking through the oil filling
hole. See figure!
6
Parts:
• A: 35 ± 3 mm
• B: Surface for motor flange
• C: Filling hole
• D: Oil level
How to fill oil is described in section:
• Changing the oil, axis-1 gearbox
on floor mounted robots on
page 150
Add oil if required.7
Tightening torque:
• 24 Nm
Refit the oil plug, inspection.8
Continues on next page
3HAC033453-001 Revision: H 117
© Copyright 2009-2013 ABB. All rights reserved.
3 Maintenance
3.3.1 Inspecting oil level, axis 1 gearbox
Continued
To Next Page
Loading...
