Removing the connected services gateway
Note/IllustrationAction
Disconnect:
• K7.X1 - K2.X3
i
• K7.X2 - A2.X5
Note
The connector K7.X2 is locked;
grab the connector, push it in to
release it and then remove the
connector.
1
xx1900001500
Carefully pull the side of the connected
services gateway and rotate it tightly to
take it out from the bracket.
2
xx1900002329
i
For connected services gateway wired, there is no power cable.
Continues on next page
214 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.2.5 Replacing the connected services gateway
Continued
To Next Page
Loading...
