Note/IllustrationAction
xx2100000318
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
2
Refitting the safety module
Note/IllustrationAction
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
When handling the computer outside of
the controller, use the wrist strap button
located on the side of the computer.
1
xx2000000419
Insert the safety module straight into the
card slots along the guide rail.
2
Screws: Screw with flange M3x6 (1 pcs)Secure the safety module with the screw.3
xx2100002176
Continues on next page
Product manual - OmniCore V250XT 283
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.2.13 Replacing the safety module
Continued
To Next Page
Loading...
