Description
Defines the minimum and maximum deviation of the Z position
from the correct value.
Z pos dev min/max
Defines the probability that an item becomes rejected by a camera.
If set to 0%, the item setting “Rejected” in the Layout will decide if
the item is rejected.
Rejection Ratio
Allows you to edit the inner and outer radius of the working area.Inner Outer Radius
Edit Layout allows you to edit the selected flow.
For more information regarding Edit Layout see the following sec-
tion.
Sector Angle(deg)
Edit Layout
xx1900000585
Description
Allows you to rename the layer.Layer ID
Allows you to select a predefined pattern template.Pattern Template
The drop down list allows you to select one item you have created for
this system.
Available Objs
Add icon allows you to add the selected item onto the layer.
Rotate icon allows you to rotate the selected items.Else Functions
Delete icon allows you to delete the selected items.
Select All icon allows you to select all the items in the layer.
Show Item Name checkbox allows you to show the name of the items.
Show Item Order checkbox allows you to show the added order of the
items.
Allows you to define the location and position of each items.Selected Item(s)
Continues on next page
152 Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.2.10 Adding Flow
Continued
To Next Page
Loading...
