2.5.2 Installing PickMaster Twin Client
Procedure
Installing PickMaster Twin Client
Note
The PickMaster 3 and PickMaster Twin Client are not recommended to be installed
on a same PC.
They may influence each other.
Note
The PickMaster Twin Client and PickMaster Twin Host are not recommended to
be installed on a same PC.
Note
The PickMaster Twin 1.0 is for IRC5 controller.
The PickMaster Twin 1.1 is for OmniCore controller.
Note
Make sure that you have installed RobotStudio on your computer before installing
PickMaster Twin Client. For the installation procedure of RobotStudio, see
Operating manual - RobotStudio.
Use the following procedure to install the PickMaster Twin Client:
1 Browse to the PickMaster Twin Client installation package and double-click
Setup.exe.
The installation starts.
xx1900001752
2 Click Next.
3 Read the license agreement and accept the terms.
4 Click Next.
5 Choose to install the Congnex vision driver and click Next.
6 Click Next.
Continues on next page
Application manual - PickMaster® Twin - PowerPac 31
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
2 Installation
2.5.2 Installing PickMaster Twin Client