4.2.6 Adding work area
Overview
This section describes how to add a work area.
xx1900000578
Adding a work area
The conveyor work area is an area on the conveyor where the robot picks or places
items. One conveyor board is required for each conveyor work area. A robot usually
has only one conveyor work area on each related conveyor, but there is no
restriction.
The Conveyor Workarea window opens as illustrated below.
xx1800001419
Description
Type a name for the conveyor work area.Workarea Name
Continues on next page
Application manual - PickMaster® Twin - PowerPac 93
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.2.6 Adding work area
To Next Page
Loading...
