2.2 System requirements
2.2.1 Hardware and software requirements
Hardware requirements
Following are the hardware requirements
• A log on account with administrator rights on the computer.
• CPU: 2.0 GHz or faster processor. Multicore processor is recommended.
• Memory: 3 GB if running Windows 32-bit edition. 8 GB if running Windows
64 bit edition. 16 GB or more if working with heavy CAD models.
• Free disk space: 10+ GB free space, solid state drive (SSD) recommended.
• Graphics card: High-performance, DirectX 11 compatible, gaming graphics
card from any of the leading vendors. For the Advanced lightning mode
Direct3D feature level 10_1 or higher is required.
• Display settings: 1920 x 1080 pixels or higher resolution is recommended.
• Dots per inch (DPI): Only Normal size supported for Integrated Vision.
• Mouse: Three-button mouse
• 3D Mouse (optional): Any 3D mouse from 3DConnexion. See
http://www.3dconnexion.com.
Note
When running the software, close other software that consumes a lot of memory,
otherwise it will affect the software normal use.
CAUTION
If robot movement can be initiated from an external control panel then an
emergency stop must also be available.
Software requirements
Following are the software requirements:
• Windows 10 (64 bit).
• Acrobat reader
• Robotstudio 2020.1 or later
• RobotWare 6.11 or later
Application manual - PickMaster® Twin - PowerPac 19
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
2 Installation
2.2.1 Hardware and software requirements
To Next Page
Loading...
Need help?
General
