Configuring a PatMax vision model
Use this procedure to configure a PatMax vision model.
1 Right-click on one Item in the tree view Cell and select Setting.
xx1800001704
The Item Setting window is opened.
xx1800001705
2 In the Item Source dialog, click Geometric.
The Image Dialog and Geometric dialog are opened.
Continues on next page
248 Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.3.9.2 Configuring a geometric model with PatMax
Continued
To Next Page
Loading...
