9 In the Analyze part, click Search to analyze the image. If needed, define sort
value.
xx1800001709
The result is displayed as an image with numbered hits in the Image dialog,
and a corresponding result list.
xx1800001710
Model hits are normally classified as accepted. If inspection is used, hits can
be classified as either accepted or rejected. See Item Properties on page 102.
Hits that do not fulfill all the requirements or hits with overlapping regions
will not be accessed by any robot and are classified as discarded. The hits
shown in the result list are marked with an icon identifying its classification.
Continues on next page
Application manual - PickMaster® Twin - PowerPac 255
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.3.9.2 Configuring a geometric model with PatMax
Continued
To Next Page
Loading...
