Note
Using distance triggered Positions Source with DSQC2000, camera or predefined
source, configure cxTrigVis as Trig signal. From RW6.10 and later, the Strobe
signal is automatically configured and can therefore be omitted in the work area
signal configuration.
Procedure
On the PickMaster PowerPac ribbon-tab, click Layout.
Use this procedure to a work area:
1 On the ribbon-tab, click Workarea.
xx1800001417
The Conveyor Workarea window opens.
xx1800001418
2 In the Conveyor Workarea window, enter a name in the Workarea Name
text box or use the default one.
3 Select the required work area type and configure the settings.
4 Click OK.
Continues on next page
Application manual - PickMaster® Twin - PowerPac 95
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.2.6 Adding work area
Continued
To Next Page
Loading...
