-EN Rev. E Operating instruction SCK Gas Sampling System 133
After first insertion, check the direction of rotation of the rotor on the heat
exchanger:
The rotor must turn clockwise. If necessary, adjust the direc-
tion of rotation by changing the phase.
Owing to the greater flow speeds in this process, after start-up the gas sam-
pling probe must be checked frequently for wear at the calcinator gas outlet
measuring point. If distinct signs of wear are visible after a short time, check
the installation position of the gas sampling probe. Failing to observe this can
lead to severe damage or total loss of the gas sampling probe.
checking the
direction of rotation
of the heat
exchanger
calcinator gas outlet
To Next Page
Loading...
