ABB SensyMaster FMT430 - Page 110

110 SensyMaster FMT430, FMT450 THERMAL MASS FLOWMETER | OI/FMT430/450-EN REV. B
… 9 Operation
… Parameter descriptions
Menu / parameter
Description
Device Setup / ...Transmitter / ...Units
Variable 1 Name
Selection of the unit for external process variables.
The transmitter can show two external process variables in the display. The process
variables can be transferred from a
fieldbus master to the transmitter via the HART®, Modbus® oder PROFIBUS
DP® protocol. You can configure the indicator
through the ‘
Display’ menu.
Variable 2 Name
Device Setup / ...Transmitter / ...Custom Units
Mass flow Qm Name
Enter the name of the user
-defined unit for mass flow.
Alphanumeric, maximum 7 characters.
Mass flow Qm Factor
Enter the factor for the user
-defined unit for mass flow.
Setting range: 0.0001 … 100000 kg/h
Mass Tot. Name
Enter the name of the user
-defined totalizer unit for mass flow.
Alphanumeric, maximum 7 characters.
Mass Tot. Factor
Enter the factor for a user
-defined totalizer unit.
Setting range: 0.0001 ... 100000 kg
Volumeflow Qv@ Name
Enter the name of the user
-defined unit for standard volume flow.
Alphanumeric, maximum 7 characters.
Volumeflow Qv@ Fact.
Enter the factor
for the user-defined unit for standard volume flow.
Setting range: 0.0001 ... 100000 m
3
/hour in standard conditions.
Volume@ Tot. Name
Enter the name of the user
-defined totalizer unit for standard volume flow.
Alphanumeric, maximum 7 characters.
Volume@
Tot. Factor
Enter the factor for the user
-defined totalizer unit for standard volume flow.
Setting range: 0.0001 ... 100000 m
3
in standard conditions.
Density@ Name
Enter the name of the user
-defined unit for standard density.
If the first character is a
space, a @ sign will be appended to the unit (standard setting).
Alphanumeric, maximum 7
characters.
Density@ Factor
Enter the factor for a user
-defined standard density.
Setting range 0.0001 ... 100000 kg/m
3
Device Setup / ...Transmitter / ...Feature Settings
FillMass On/Off
FillMass function active?
Off
: FillMass function deactivated.
On
: FillMass function activated.
FillMass Code
Sets the device
-specific code for activating the FillMass function. To use this function subsequently, contact the ABB
service team or sales organization.
After entering the code, restart the device (by for example
using the parameter ‘Perform Device Reset’, or by briefly
switching off the power supply).
VeriMass On/Off
VeriMass
function active?
Off
: VeriMass function deactivated.
On
: VeriMass function activated.
VeriMass Code
Sets the device
-specific code for activating the FillMass function. To use this function subsequently, contact the ABB
service team or sales
organization.
After entering the code, restart the device (by for example using the parameter ‘
Perform Device Reset’, or by briefly
switching off the power supply).