ABB SensyMaster FMT430 - Parameterization Via the Menu Function Easy Setup

76 SensyMaster FMT430, FMT450 THERMAL MASS FLOWMETER | OI/FMT430/450-EN REV. B
Parameterization via the menu function Easy Setup
Settings for the most common parameters are summarized in
the ‘Easy Setup’ menu. This menu provides the fastest way to
configure the device.
The following section describes parameterization via the ‘Easy
Setup’ menu function.
Qm
0.00
kg/h
∑m
0.00
kg
Tm
0.0
°C
1. Switch to the configuration level with .
Access Level
Read Only
Standard
Back
Select
2. Use / to select ‘Standard’.
3. Confirm the selection with .
Enter Password
**********
RSTUVWXYZ
012345
Next
OK
4. Use to confirm the password. A password is not available
as factory default; you can continue without entering a
password.
Menu
Easy Setup
Exit
Select
5. Use / to select ‘Easy Setup’.
6. Confirm the selection with .
Selection of the menu language
Easy Setup
Language
Next
Edit
7. Use to call up the edit mode.
8. Use / to select the desired language.
9. Confirm the selection with .
Configuration of the current output
Easy Setup
Curr.Out 31/32/Uco
Mass Flow [%]
Next
Edit
10. Use to call up the edit mode.
11. Using / , select the desired process value for current
output 31 / 32 / Uco.
12. Confirm the selection with .
Easy Setup
Only if an appropriate plug
-in card is
present!
Curr.Out V1/V2
Mass Flow [%]
Next
Edit
Easy Setup
Only if an appropriate plug
-in card is
present!
Curr.Out V3/V4
Mass Flow [%]
Next
Edit
13. Use to call up the edit mode.
14. Use / to select the desired process value for current
output V1 / V2 or V3 / V4.
15. Confirm the selection with .