ABB SensyMaster FMT430 - Menu: Device Setup

106 SensyMaster FMT430, FMT450 THERMAL MASS FLOWMETER | OI/FMT430/450-EN REV. B
… 9 Operation
… Parameter descriptions
Menu: Device Setup
Menu / parameter
Description
Device Setup
...Access Control
Selection of submenu ‘...Access Control
’ using .
...Sensor
Selection of submenu ‘...Sensor’ using .
...ApplicationSelector
Selection of submenu ‘...ApplicationSelector’ using .
...Application 1
...
...Application 8
Selection of submenu ‘
...Application 1’ ... ‘...Application 8’ using .
...Transmitter
Selection of submenu ‘...Transmitter
’ using .
Device Setup / ...Access Control
Standard Password
Entry / change of the password for the ‘
Standard’ access level.
Read Only Switch
Indicator of the
position of the write protection switch.
For further information, see chapter Hardware settings on page 72.
Device Setup / ...Sensor
Sensor Location Tag
Enter the measuring point
tagging for the sensor.
Alphanumeric, max. 20 characters
Sensor Tag
Enter the tag number for the sensor.
Alphanumeric, max. 20 characters
Device Setup /
...ApplicationSelector
Application
Application selection (type of measuring medium)
•
Air: Using the device with factory calibration for air.
•
Application 1 ... 8: Selection of the appropriate application. The individual applications are configured in the ‘Device
Setup / ...Application 1 ... 8’ menu.
Dig.In 0 Application
Use of
optional digital inputs for application switching. You can switch between four applications by wiring the digital
inputs.
•
Dig.In 0 Application: Assignment of the application if no digital inputs are active.
•
Dig.In 1 Application: Assignment of the application if only digital input V1 / V2 is active.
•
Dig.In 2 Application: Assignment of the application if only digital input V3 / V4 is active.
•
Dig.In1+2Application: Assignment of the application if only digital input V1 / V2 and V3 / V4 are active.
Note
The function is available only with the corresponding plug
-in cards in place! The digital inputs must be configured in the
“
Input/Output / ...Dig.In V1/V2” or “Input/Output / ...Dig.In V1/V2” menu using the “Act. App.Selector1|3” function or “Act.
App.Sel
ector2|3” function.
Dig.In 1 Application
Dig.In 2 Application
Dig.In1+2Application