Adtech ADT-DK300A - Speed Rate Adjustment

BZ001M056A ADT‐DK300A/400A Engraving Machine

27
(3)SelectUSBdiskandpress[EOB]toenter;
(4)Movecursortoselectafileinthedisk;
(5)Press[EOB]toloadthefileintoworkarea(systembuffer);
(6)Pressmodeselectionkey[Auto];
(7)Pressthe[Start]keytoruntheprogram,andtheindicatorison.

0 Caution
Thesystemwon’trecordtheUSDdiskpath.IfpowerfailureoccursduringDNCprocessing,theprograminfowillbelost
whenthepowersupplyisconnectedagain.


4.4 Speedrateadjustment
Feedingrate
Inautomaticmode,press
/  keyin[Position]interfacetoadjustthefeedingrate;Press
thekeyoncetoincreaseordecreaseby10%(10%‐150%).
Manualrate
Inmanualmode,press
/  keyin[Position]interfacetoadjustthemanualrate;Pressthe
key to increase or decrease by 10% (10%‐150%). If you press the
 key and /  key ,
youcanadjustthefastforwardrateby10%(10%‐150%).
Principalaxisrotation
In automatic or manual mode,pressthe
/  key to adjust the principal axis rotationby
100r/min. The maximum rotation is set by the principal axis parameters in the system and the minimum
rotationis16r/min.Ifyoupressandholdthekeyforthreeseconds,thevaluewillbeincreasedordecreased
quickly.