Adtech ADT-DK300A - 9 System Maintenance; Restart

BZ001M056A ADT‐DK300A/400A Engraving Machine

58
9. Systemmaintenance
9.1. Restart
Afterprogramupdate,you needto restartthe system to make thesettings takeeffect.Cold startand
warmstartareavailable.Forcoldstart,turnoffthepowersupplydirectly,andthenturnon;forwarmstart,
carryoutthefollowingoperationwhenthesystemisrunningnormallyandthe
processingisstopped:
(1)Inthemainmenu,press[
]toentertheprograminterface;
(2)Press[File]toenterthefileinterface;
(3)Press[
]andthesystemaskswhetherrestartornot,asshowninFig.9‐1;

Fig.9‐1
(4)Press[ ]torestartthesystem.
Inthefilemanagementinterface,youcanalsopress
onthepaneltoenterdirectly.
