Adtech ADT-DK300A - Editing & Modifying Programs; Deleting Files; Deleting Files in Memory; 8 Main Interfaces of the System

BZ001M056A ADT‐DK300A/400A Engraving Machine

38
7.3 Editing&modifyingprograms
TheprograminCNCmemorycanbeeditedwithNCkeypad.Inthemainmenu,press[Edit]toenterprogrameditinterface
andedittheprogramincurrentworkarea(forloadingprogramintoworkarea,refertosection8.2).Theeditmodeis
similartonotepadinW indows.Movethe
cursordirectlytolocate,presskeystoenter,press[EOB]tochangeline,and
press[Delete]todeletethecharacterwherethecursorlocates.
0 Caution
Afteralloperations,pressResettosavethefiles,andthefunctionsbaseoneditmode;
DK300Ausesnewfilemappingtechnology,andallowsloadingprocessingfilesthatexceeditsmemory.Therefore,to
ensurethesystemefficiency,youcanonlysearchandprocess,butcan’tedittheprocessingfilesthatexceed2MB.
7.4 Deletingfiles
7.4.1. Deletingfilesinmemory
Followthestepbelowtodeletetheprogramsinsystemmemory:
Press[File]toenterfileoperationinterface;
Followthepromptonthescreen,selectthefileandpress[Delete]toconfirmanddeletethefile.
0 Caution
Iftheprogramhasbeenloadedintoworkarea,youneedtorestartthesystemtodeletetheprogram,orelsethesystem
willreporterror.
Theprogramsloadedintotheworkareacan’tbedeleted,orelsethesystemwillreporterror.
8. Maininterfacesofthesystem
8.1. Positioninterface
The position interface shows current machine tool coordinates, including absolute position, relative
positionandcomprehensiveposition.Inthemaininterface,press[Monitor]toenterthepositioninterface.
Toenterpositioninterface: