Adtech ADT-DK300A - 4 Automatic Operation

BZ001M056A ADT‐DK300A/400A Engraving Machine

24
4. Automaticoperation
4.1 Automaticoperation
ThemachinetoolcanoperateaccordingtotheprograminDK300Amemory,whichiscalledasmemory
operation.
Theprogra misprestoredinthememory.Selectandloadaprogramwiththeoperationpanelandpress
the“
”keytostarttheautomaticoperation.Then,press“ ”keytopause,press“ ”key
againtoresumetheoperation,andpress“
”duringoperat iontostoptheprogramimmediately.
Thestepofmemoryoperationfollows:
⑵ Savetheprograminthememory(seesection8.1fordetails);
⑶ Select[Edit],[File]inthemenuorpress[File]onthepaneltoenterfileoperationinterface;

Disk C is YAFS file system disk, which is dedicated system disk. Disk D is FAT data disk, which saves
processing filesand systemsettings aswell as PC interactive data.Removable USB disk saves external user
data.
⑷ Press
, , ,  to movethecursor,press[ ] to select aprogram
andloadthefileintotheworkarea;asshowninthefigurebelow