Adtech ADT-DK300A - Parameter Backup and Restore

BZ001M056A ADT‐DK300A/400A Engraving Machine

61
(5)Press ,thesystemaskswhetherclearallparameters,asshowninFig.9‐3;press[EOB]again,
thesystemrestoresthedefaultparametersandrestartsautomatically.

Fig.9‐3
9.4. Parameterbackupandrestore
This function can back up the modified parameters. When the system is updated or initialized, the
parameters can be restored to avoid setting the parameters repeatedly. The backup files can be copied to
otherengravingsystem.Therefore,pleasebackuptheparametersafteradjustingandrestoretheparameters
directlyinthe
newmachine.Theparameterbackupandrestoremethodisdescribedbelow:
(1)Selecttheeditmode;
(2)Inthemainmenu,press[Parameter]toentertheparameterinterface;
(3)Pressthe[Management]keytoenterthemanagementparameterinterface;
(4)Movecursorto007or008,andselectcorrespondingoperation
menu;
(5)Press[EOB],thesystemconfirms,andperformsbackuporrestoreoperation;
(6)ThebackupoperationwillgeneratetheSYSCONF.BAKfileintherootdirectoryofdiskD.Pleasesave
thisfileforbackupinthefuture.