BZ001M056A ADT‐DK300A/400A Engraving Machine
11
) Note
Thetoolalsocanreturntoreferencepointaccordingtoprograminstruction,i.e.returningtoreferencepoint
automatically.
0 Caution:
Generally,thesystemwillperform homeoperationafterconnectingthepowersupply.Ifthepowerfailswhilethe
machinetoolismoving,thesystemalsowillreturntoreferencepointwhenthepowersupplyisconnectedagain.Return
toZaxistopreventtoolandworkpiecefromcolliding,anddamagingtool,workpieceandclamp.
3.2 Continuousfeedingmanually
Pressthekeysontheoperationpanelorhandwheeltomovethetoolalongeveryaxis.
Theoperat ionfollows:
⑴ Pressthemodeswitchkey[
]toselectmanualoperation;
(2) Press composite keys [
], [ ]; [ ], [ ]; [ ], [ ]; [ ],
[
]innumbersareatomovethetoolalongselectedaxis.
Inmanualmode, keycanbeusedtoswitch themanual speedandrapidtraversespeed.The
rapid traverse speed of every axis depends on General parameter 009‐012 (rapid traverse speed setting).
Afterswitchingtorapidtraversespeed,themanualspeedofthepositioninterfacewillbehighlighted,while
theactualspeed
ofthepositioninterfaceissampledfromthemovingspeedofcurrentaxis. Thisvaluecan
trulyreflectthemovingspeedofcurrentaxis(unit:mm/min);
) Note:
Onlysingleaxismotionisavailableinmanualmode.
3.3 Singlestepfeeding
Singlestepmodeissimilartomanualmode,theoperationsaresame,butonlymovesaspecifiedpulse
incrementeverytimepressthekey .
To Next Page
Loading...
