Adtech ADT-DK300A - Alarm Processing; Self-Diagnosis Function

BZ001M056A ADT‐DK300A/400A Engraving Machine

35

 InterfaceaxisNo.setbyparameterP2.45~P2.49isspecifiedrepeatedly
1047
: spinotohome


1048
: workpiecenolock


1049
: safesignalcan'tdetect


1051
: airnoenough


1052
: chucksignalalarmdetect


6.3  Alarmprocessing
Ifalarmoccurs,pleaserefertothealarmcodetoconfirmthefailurereason.
When alarm occurs,if the system isn’treset,thealarm willconstantlypromptno matterwhetherthe
alarmstillexists,soastoavoidtheconditionsthatfalsealarmcausessystemsus p ended,butcan’tfindthe
reason.

Iftheerroriscausedbydatasetting,modifythedata,andthenpress[Reset]toclearthealarminfo.
Whenalarmoccurs,pleaseremovethealarmreason.Pleasenotethatseveralalarmsmayoccuratthe
sametime.PleaserefertothealarminfointheDiagnosismenufor
details.Whenthealarmsareeliminated,
pleasepress[Reset]toclearthealarmring.

6.4 Self‐diagnosisfunction
TheCNCsystemmaystopevenwhenthereisnoalarminfo,thismaybebecausethesystemisexecuting
certainprocesses.Pleasecheckwiththeself ‐diagnosisfunction.