Adtech ADTECH4 CNC Series - Page 116

ADTECH4 SeriesCNC Maintenance Manual
Authority
:
Operation admin
Default
:
0
Effective time
:
Instant
Note
:
When P1.044 or P1.045 is enabled and set to workpiece coordinates or
machine coordinates, it is used to set the safety height automatically
lifted (workpiece coordinates or machine coordinates) when A-axis or
Z-axis pauses in the processing or executes home operation in home
mode.
051
Z-axis feed rate limit
052
A-axis feed rate limit
Range
:
0~20000
Unit
:
mm/min
Authority
:
Operation admin
Default
:
0
Effective time
:
Instant
Note
:
When Z-axis or A-axis is used as the cutting feed axis, it sets the
maximum G01 cutting feed rate.
053
Thread cutting acceleration pitch P (L series)
054
Thread cutting acceleration pitch D (L series)
055
Thread cutting backslide amount V (L series)
Range
:
0~100
Unit
:
mm
Authority
:
Operation admin
Default
:
0
Effective time
:
Instant
Note
:
To set the pitch length of acceleration segment of lathe CNC4620 system
thread cutting command G32 & G92, pitch length of the deceleration
segment and run-out amount. For details of G32 G92 instruction, see
CNC4620 programming manual.
056
Enable jump to M98 * times * lines