156 © 2002 ADTRAN, Inc. 61200600L1-1A
Section 5 DLP-008 Total Access 600R System Manual
Prior to the start of the upgrade, the transfer status will display IDLE. During the TFTP upload, various
status messages display in T
RANSFER STATUS to indicate progress. The following table describes
these messages.
8. When the update has successfully completed, FLASH PROGRAMMED SUCCESSFULLY will display briefly
in the T
RANSFER STATUS field. This will be followed by a LOADED CODE VER X.X.X CHKSUM = XXXX
message. Finally the T
RANSFER STATUS field will display RESETTING...
The unit will restart immediately and resume operation. After giving the unit sufficient time to reboot,
the user may Telnet back into the unit and log in.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
Message Meaning
Transferring... [X KB] Indicates communication with the TFTP network server has been
established and the update file is being transferred between the unit and
the TFTP network server.
Flash Programmed
Successfully
The unit has been upgraded successfully.
Loaded code
ver x.x.x
chksum = xxxx
Unit displays the version and checksum of the upgraded code.
Resetting.... Unit is power cycling.
RECV Error Unit will display this message if server filename is incorrect.
Host Timeout Unit will display this message if TFTP server address is incorrect.
idle The upgrade has not yet been initiated.
To Next Page
Loading...
Need help?
General
