61200600L1-1A © 2002 ADTRAN, Inc. 169
SAVING AND LOADING TEXT CONFIGURATION USING THE TERMINAL
COMMAND LINE
Introduction
The unit has the ability to download a text file which contains the configuration of the entire unit. This
configuration may be altered in a text editor and then uploaded to the unit.
This DLP will explain how to save and load the configuration.
Prerequisite Procedures
You must connect to the unit with a VT100 terminal session (reference DLP-001 and DLP-002) or via a
Telnet session (reference DLP-006, Telnetting to the Unit).
Tools and Materials Required
• Access to a PC or other computer connected to the LAN (Telnet access only).
• VT100 compatible terminal or computer with terminal emulation software.
• Appropriate cable to connect terminal to the unit (customer-provided).
• DB-9 female to RJ-45 female adapter for connecting to the
CRAFT port on the rear of the unit. This
adapter is ADTRAN-proprietary and is shipped with the unit.
• Ethernet cable from the
10/100BASET port on the unit to a hub (customer-provided).
• Use Ethernet crossover if going from the unit to a PC (customer-provided).
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
To Next Page
Loading...
Need help?
General
