Total Access 600R System Manual Section 4 User Interface Guide
61200600L1-1A © 2002 ADTRAN, Inc. 81
L2 PROTOCOL (ETH[1]) > STATUS > CLEAR COUNTS
Selecting this activator clears all the Ethernet stats.
BRIDGE
Configure the bridge parameters and view bridging statistics from this menu as shown in Figure 8.
Figure 8. Bridge Menu
BRIDGE > CONFIG
Configure the interfaces and bridge table parameters from this menu.
BRIDGE > CONFIG > INTERFACES (T1[0])
Configure the T1 interface bridging parameters from this menu.
The T1[0] interface will not appear as a bridge interface entry if the mode is set to route
IP.
To Next Page
Loading...
