Section 4 User Interface Guide Total Access 600R System Manual
52 © 2002 ADTRAN, Inc. 61200600L1-1A
SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > ACCEPT ALL SNMP
When set to ON, SNMP gets/sets received over the FDL link are always accepted regardless of the
community table. When set to
OFF, the community table is searched for valid manager IP addresses and the
SNMP traffic is rejected if a match is not found. Default is
ON.
SYSTEM CONFIG > SYSLOG
Configure the unit Syslog client for use with a Syslog server (supplied with ADTRAN Utilities or available
on most Unix platforms) from this menu.
SYSTEM CONFIG > SYSLOG > SYSLOG IP
IP address of the syslog daemon to which log message should be sent. The values must be dotted decimal
notation.
SYSTEM CONFIG > SYSLOG > SYSLOG FORMAT
The SYSLOG FORMAT is the format of log messages. "ADTRAN" uses a format that is compatible with Adtran
Utilities and forces the Syslog Facility to LOCAL0.
UNIX uses the traditional Unix format and reports at the
configured facility level.
SYSTEM CONFIG > SYSLOG > SYSLOG FACILITY
The choices are: LOCAL0, LOCAL1, LOCAL2, LOCAL3, LOCAL4, LOCAL5, LOCAL6, LOCAL7. SYSLOG FACILITY
is the facility level for all messages forwarded from the unit to the syslog server. This allows all messages
received from the IAD to be filtered by facility level. See RFC3164: The BSD Syslog Protocol.
For additional information, reference RFC3164: The BSD Syslog Protocol.
Adtran Utilities may malfunction if messages are received in the Unix format.
This does not have to correspond to the facility level shown in the terminal mode option.
See SYSLOG using Terminal Mode on page 53.
To Next Page
Loading...
Need help?
General
